New firmware release is ready and it will be uploaded soon. This new FW will improve CAT commands performance. CAT commands FR; and FT; now work correctly showing receiving and transmitting VFO.
Also a new feature has been implemented in CAT command set – IF bandwidth BW. Bandwidth CAT command BW can be read or set. Here is BW syntax:
Read: BW;
Set: BWP1P2P2P2P2 where P1 is narrow filter status (FIL button on front panel) on/off. Values are 1 or 0; P2 – IF bandwidth four digits – 0000 – 9999;
Answer: BWP1P2P2P2P2
Possible answers are from 240Hz to 2800Hz. If you try to assign parameter bellow or higher than this range – then parameter will be set to nearest value. If parameter P1 is set to 0 then other parameters (P2) will be ignored and IF bandwidth will be set to first roofing filter (2.3, 2.7 or 2.8kHz).